
Status 3-20 Way Alarm Panel
Product Overview
When any alarm input circuit receives a signal, the appropriate alarm LED will flash with the sounder and alarm relays turning ON. Pressing the reset switch will mute the sounder, and turn the red flashing alarm LED on constant, the relays will reset (option – non resettable relays). When the alarm signal has cleared pressing the reset switch will clear the alarm LED.
- 20 Sensor Input Chanels
- Visual and Audible Alarm
- Wall Mountable
Additional Information
PDF Downloads
General Enquiries
Tel. +44 (0) 113 2860166
Email:
admin@gds-technologies.co.uk
Sales Enquiries:
Tel. +44 (0) 113 2878187
Email:
sales@gds-technologies.co.uk
Technical Engineering Advice
Tel. +44 (0) 113 2878184
Email:
admin@gds-technologies.co.uk
Status 3-20 Way Alarm Panel System Funcltion: When any alarm input circuit receives a signal, the appropriate alarm LED will flash with the sounder and alarm relays turning ON. Pressing the reset switch will mute the sounder, and turn the red flashing alarm LED on constant, the relays will reset (option – non resettable relays). When the alarm signal has cleared pressing the reset switch will clear the alarm LED. System Test:
Pressing the reset pad for 15 seconds will turn all the alarm indicators on (stage 1), maintaining the reset pad on for a further 15 seconds will activate alarm relays and corresponding remote indicators (stage 2).
Power Supply | 230/110V AC and/or 24V DC |
Power consumption max | 15 Watts |
Indicators | |
Alarms (20 off) | Red LED’s Conditions: Alarm mode – Flashing Accept mode – Constant |
Fault Alarm | Amber LED |
Power | Green/Red LED Conditions: Mains On – Green State Mains Fail – Red State (battery back-up mode) |
System Test | Stage 1 Alarm LED’s – ON Stage 2 Alarm relays – ON |
Outputs | Alarm Relays (1) 3 sets S.P.C.O.(Rating 5A 230vAC) Latched until alarm reset (option – not resettable until signal has cleared – factory setting) Fault Relay – Set S.P.C.O Rating 5A 230v AC Mains Fail Relay – Set S.P.C.O Rating 5A 230v AC |
Audible Alarm | Conditions: Gas / Fault Alarm (permanent mute option) |
Signal Inputs – 20 way | +24V DC (6 outputs) Field contacts, closing for alarm (20 inputs) Field contacts, closing for alarm Fault (1 input) Option at manufacture Alarm field contacts opening for +24V maintained alarm (loop failure monitored) connect jumper JP1-JP20 for unused inputs |
Miscellaneous | Enclosure Wall mount – steel enclosure IP52 314W 264H 55D Cable entry Base or rear Field terminals 2.5mm Remote reset 2 wire – N/O Remote sounder 2 wire – 24v DC |
Options | Channel Alarm Relays Add on board – 1 relay per channel |
Top Accessories
For a full list of related products available please contact us via email sales@gds-technologies.co.uk